Text only | Text with Images

The Hillman & Chrysler Avenger Forum

Avenger Related => For Sale or Wanted => Topic started by: urarchenemy on July 24, 2013, 06:05:34 PM

Title: FS, worked 1600 motor, box and all the bits to go with
Post by: urarchenemy on July 24, 2013, 06:05:34 PM
I have a fully worked 1600 motor, cam out of a mini sprint. Was pulled out to replace with something bigger. Made by hillspec performance. hillspec cam, aluminium pistols, regrafted distributor, same with fuel pump, match ported head, shaved block, shaved head, lightened flywheel, original flywheel, brand new head gasket, brand new tapped cover gasket, twin side draughts ( 40mm solex carb ) , starter motor, ulternator,  linkage for twin carb set up, 4 speed gearbox, clutch, pressure plate clutch cable, engine mounts. Aiwi 1500 for the lot or near offer! This motor has had well over $6000 work put into it!
Title: Re: FS, worked 1600 motor, box and all the bits to go with
Post by: urarchenemy on July 24, 2013, 08:25:51 PM
Yes it is a 1600 from an avenger
Title: Re: FS, worked 1600 motor, box and all the bits to go with
Post by: urarchenemy on August 01, 2013, 01:19:17 PM
Make me an offer! Need it gone!
Title: Re: FS, worked 1600 motor, box and all the bits to go with
Post by: scott on November 26, 2014, 08:38:40 AM
will it fit in 63 humber?
Title: Re: FS, worked 1600 motor, box and all the bits to go with
Post by: blekkja on December 21, 2014, 06:25:40 PM
This still up for sale? Where are you based?
Title: Re: FS, worked 1600 motor, box and all the bits to go with
Post by: blekkja on December 22, 2014, 05:47:58 PM
Oh shit, this was necroed from 18 months ago. Nevermind.
Text only | Text with Images